How to fix a failed task with the AI assistant

For server administrators · Updated 2026-10-29

On this page
  1. Before you start
  2. Steps
  3. Good to know
  4. Common questions

Every change on the server (creating an account, issuing a certificate, a backup…) runs as a task. When one fails, its output says why, but not always in plain words. The assistant reads it for you.

Before you start

  • You are the administrator. The buttons are shown only to administrators.
  • The AI assistant is turned on. See turn on the AI assistant.

Steps

  1. In the admin panel, open Task Queue.
  2. Click the failed task. Its page shows the type, the times and the output, with the badge failed.
  3. Choose one:
    • Explain with AI — a short explanation of why it failed and what to check appears on the same page, under AI assistant.
    • Fix with the assistant — opens the AI assistant with the message "Task #N (type) failed. Find out why and fix it." filled in. Click Send.
  4. With Fix with the assistant, the assistant reads the task's full output, checks the server and proposes a fix, for example restarting a service. Click Confirm to allow it.
  5. When the cause is fixed, the assistant can run the task again (after your confirmation), or click Retry on the task page yourself.

Good to know

  • Explain with AI works only on failed tasks: "Only a failed task can be explained."
  • The answer under AI assistant says "Written by AI from the facts on this page; check before you change anything important."
  • Passwords and keys in the task output are hidden before it is sent.

Common questions

I don't see the buttons.

The task has not failed, you are not logged in as the administrator, or the assistant is off.

The assistant cannot fix it.

Some causes are outside the server, for example a domain that does not point to it. The assistant then tells you what to check and change yourself.

Was this article helpful?

Still stuck?

Ask the AI about your exact situation — it answers from this knowledge base — or contact us.